Guide · Costs

The hidden costs of crypto trading

The hidden costs of crypto trading are the ones an exchange’s fee schedule does not list: the spread, slippage, funding on perpetual futures, and the fee to withdraw. None of them is secret, but each is charged in a different place from the trading fee. On a leveraged position held for a week, they can come to three times the fee itself.

Published 22 November 2026 Education, not advice

One trade, five costs

CostIn the exampleWhere it shows upWhen it is paid
Trading fee$10The exchange’s fee scheduleOn every fill
Spread$2The gap between best bid and best ask in the order bookOnce per round trip made with market orders
Slippage$6Your average fill price against the price you sawOn each order that takes from the book
Funding$21The contract’s funding rate and transaction historyAt each funding settlement while the position is open
Withdrawal fee$1The withdrawal form, per coin and networkPer transfer out
Total$40The trading fee is 25% of it

Illustration with round numbers, not a reading from any exchange: a $10,000 long on a perpetual, opened and closed with market orders at a 0.05% taker fee, a 0.02% spread, 0.03% slippage per order, funding of 0.01% every 8 hours for 7 days (21 settlements, rate held constant and positive), and one withdrawal at a flat $1.

What counts as a hidden cost

A hidden cost is anything a trade costs that the exchange’s fee schedule does not list. The schedule shows the maker and taker fee. It does not show the spread you cross, the slippage on your fill, the funding paid while a perpetual is open, or the fee to move money out. On a position held for days, these can add up to more than the fee.

On the 9 exchanges AffMiss compares, the base-tier futures taker fee runs from 0.035% to 0.06%, so entering and leaving a $10,000 position with market orders costs between $7 and $12 in fees. That is the visible part. The worked example on this page uses a 0.05% taker fee and round illustrative numbers for everything else. None of those other numbers is a reading from any exchange.

Spread: the cost of crossing the book

The spread is the gap between the best bid and the best ask, and a market order pays it. You buy at the ask and sell at the bid, so one round trip with market orders costs about one full spread on top of the fee. On a $10,000 position, a spread of 0.02% is $2.

The spread is not fixed. It is narrowest on the most traded contracts during busy hours and widens on thin contracts, in quiet hours and around sharp moves. The order ticket shows the current bid and ask before you send anything, which makes the spread the easiest of these costs to check in advance.

An order that rests in the book does not cross the spread, which is one reason maker orders cost less than taker orders by more than the difference in fee.

Slippage: when the order is larger than the best price can fill

Slippage is the difference between the price shown when you send an order and the average price it fills at. It appears when the order is larger than the quantity resting at the best price, or when the market moves first. At 0.03% per order, a $10,000 position loses $3 on entry and $3 on exit, $6 in all.

Slippage grows with order size and with speed of the market. A stop order that triggers a market order during a sharp move is the usual place it becomes large, because many stops trigger at once into a thinning book. The mechanics, and how to estimate it from the order book, are covered in slippage in crypto trading.

AffMiss has no slippage measurements for any exchange. The 0.03% above is an illustration. The figure for your order is the estimated fill price on the order ticket, compared with the mid price.

Funding: the cost of holding a perpetual

Funding is a payment between long and short traders on a perpetual future, settled at fixed intervals on the full position value. At 0.01% every eight hours, a $10,000 long pays $1 per settlement, $3 a day and $21 over seven days. In this example that is 2.1 times the $10 round-trip taker fee.

Funding is charged on the position, not on the margin. At 10× leverage the position above is backed by $1,000, so $21 of funding is 2.1% of the money actually posted. Held for 30 days at the same rate, funding reaches $90. A constant 0.01% per eight hours is 10.95% a year without compounding.

Two things separate funding from a fee. The rate changes at every interval, and it can be negative, in which case longs receive it and shorts pay. A short in the example above would have received $21. How the rate is set is explained in funding rate explained, and the funding cost calculator works out the amount for any position size, rate and holding period.

Withdrawal and deposit costs

A withdrawal fee is a flat amount per transfer, set by the exchange for each coin and network, and it does not shrink with the amount sent. A $1 fee is 2% of a $50 withdrawal and 0.02% of a $5,000 one. Small, frequent withdrawals are where it costs most: once a week at $1 is $52 a year.

The same coin can usually leave on several networks at different fees, and the cheapest one is only usable if the receiving side supports it. That choice is covered in choosing a withdrawal network. AffMiss has no dated reading of withdrawal fees yet, so each review marks them as not recorded. The current figure is on the exchange’s own withdrawal page.

Getting money in can cost more than getting it out. Depositing crypto normally carries no exchange fee, only the network fee paid where it was sent from. Buying crypto with a card or a bank transfer often carries a fee or a conversion spread. As an illustration, 1% on a $2,000 purchase is $20, the same as the taker fees on $40,000 of trading volume at 0.05%.

Costs that apply only to some trades

Some costs apply only to particular products or events. A liquidation can take the whole margin of a position and, on many exchanges, a liquidation fee with it. Borrowed coins on spot margin accrue interest. Converting between currencies carries its own spread. Each is set out in the exchange’s rules, though rarely on the fee page.

  • Liquidation: the position is closed by the exchange once its margin runs out, as described in crypto liquidation explained. The contract rules state whether any margin left over is returned.
  • Interest on spot margin: borrowing a coin to trade it is a loan with a published interest rate, charged for as long as the loan is open.
  • Conversion: swapping one stablecoin or currency for another through a convert feature is priced with a spread instead of a visible fee.
  • Fee discounts paid in an exchange token: the discount is real, and so is the price risk of holding the token that earns it.
  • Options: some exchanges list a delivery or exercise fee separately from the trading fee.

Adding it up: one trade, five costs

For the example trade, a $10,000 long opened and closed with market orders and held seven days, the total is $40: $10 in fees, $2 of spread, $6 of slippage, $21 of funding and $1 to withdraw. The fee on the schedule is a quarter of it. The price has to move 0.4% in your favour before the trade breaks even.

At 10× leverage, $40 is 4% of the $1,000 margin. Close the same position on the day it was opened, before a funding settlement, and leave the money on the exchange, and the cost falls to $18. Hold it for 30 days instead and it rises to $109, of which the trading fee is about 9%.

Which line dominates depends on how you trade.

  • Many short trades: fees, spread and slippage repeat on every round trip. Twenty round trips of $10,000 a month at the example rates cost $200 in fees and $160 in spread and slippage, and little or no funding.
  • Positions held for weeks: funding becomes the largest line, and the trading fee matters least.
  • Buying spot to hold in your own wallet: one trading fee, the spread, and the withdrawal fee. There is no funding on spot.

How to reduce each cost

Each cost has its own lever. Resting limit orders avoid the spread and slippage and pay the lower maker fee. Shorter holding periods and attention to the funding rate limit funding. Fewer, larger withdrawals on a cheaper network cut transfer costs. Choosing an exchange on its taker fee alone addresses one of the five lines.

The largest single saving in the example comes from the order type. Entering and leaving with resting orders at a 0.02% maker fee costs $4 in fees, with no spread crossed and no slippage, against $18 for the market-order version. That is $14 less per round trip. The price of it is that a resting order may not fill.

For the fee line itself, the published futures and spot fees of each exchange are listed with their sources, and the ranking of the lowest-fee crypto exchanges by published rates weights them for traders who mostly place resting orders. The exchange cost comparison tool prices a month of your own volume at each exchange.

What AffMiss compares, and what it leaves out

AffMiss compares published maker and taker fees, each with a source and a reading date. It has no measurements of spread or slippage on any exchange, and no dated reading of withdrawal fees or funding terms yet, so none of those enter the fee index. A high fee index means low published fees. It does not mean a low total cost.

The limits of the index are set out in the methodology. Until those other figures are read and dated, the working rule is to use the fee comparison for the fee line, and to check the spread, the funding rate and the withdrawal fee on the exchange itself before a trade whose cost depends on them.

Where to go next

Common questions

The costs that do not appear on the trading fee schedule: the bid-ask spread, slippage on the fill, funding on perpetual futures, withdrawal fees, and deposit or conversion charges. They are published or visible elsewhere on the exchange, but they are not part of the maker and taker fee.

This guide explains how a product works. It is not financial advice. Leveraged crypto products can lose your entire margin. Read the risk warning.